Ultraflex ND1-MM, Installation Manual

Page: 24 / 40

Installation manual
ULTRAFLEX
page 24
of 39
- ZTF SYSTEM
9
Afterwards, while holding a screw with a
9/16" wrench, fasten the corresponding nut
with a torque of 54 Nm (40 lb.-ft.). Repeat this
operation on the other nut always by holding
its screw.
Double-check the tightening of screws and
nuts by repeating the same procedure de-
scribed in points 8 and 9 (fastening screws
and nuts while holding screws).
CAUTION
This check requires careful attention.
10
Complete the assembly of UC130 cylinder on the outboard engine following what is reported on
the installation and maintenance manual of the cylinder itself, except for the fastening phase of the
cylinder link arm to the engine arm, which is described in the previous points.
WARNING
Do not disconnect the hydraulic hoses for any reason.
11
Assemble the tiller handle on the ZTF device as described in paragraph 3.7.
12 Insert caps to protect nuts on the engine side
bracket.