Ultraflex ND1-MM, Installation Manual

Page: 29 / 40

ZTF SYSTEM
-
page 29
of 39
Installation manual
ULTRAFLEX
1 The main body of the tiller handle
must be fastened to the device in line
with the fork.
Fasten the tiller handle (1) to device
(2), taking care of positioning bush-
ings, spacers and washers as shown
in the picture aside (following the
same order in which they were dis-
assembled).
After having lubricated bolt (3), fasten
nut (4) with a tightening torque be-
tween 29.4 and 34.3 Nm (from 21.68 to
25.29 lb.-ft.), avoiding excessive play of
the handle allowing its tilt to any angle.
Check that the upward and downward
movements of tiller handle are correct
and there is no free play along the
horizontal axle, enabling the proper
functioning of the device.
CAUTION
Apply grease to the screw shafts be-
fore tightening the nuts.
1
4
2
3
SUZUKI