Ultraflex ND1-MM, Installation Manual

Page: 30 / 40

Installation manual
ULTRAFLEX
page 30
of 39
- ZTF SYSTEM
1 Remove the tiller handle
from the engine arm, taking
care of keeping the extracted
nuts and washers. Check their
conditions together with the ring
preventing the nut lock. Replace
any even slightly damaged com-
ponents (in this case, contact the
technical service).
Proceed with assembling the
device following what is report-
ed in paragraph 3.4 and 3.5.
3.9 Wiring
P roceed with replacing the cables (shift and throttle) and with connecting th e tiller handle to the engine controls
(throttle, shift, ignition, etc.) following the instructions supplied by engine manufacturer.
3.8 Tiller handle disassembly from outboard engine
("refitting" installation)
1 Remove the tiller handle
from the engine arm, taking
care of keeping the extracted
washers. Check their conditions.
Replace any even slightly dam-
aged components (in this case,
contact the technical service).
Proceed with assembling the
device following what is report-
ed in paragraph 3.3.
NOTICE
The screws must be replaced by
those included in the kit.
MERCURY MARINE
YAMAHA
WARNING
After the installation of the ZTF system in Suzuki engines, the electric wiring could be no more suitable. In this
case, contact Suzuki for a new electric wiring.