ULTRACOM KOIRA-GPS, Manual

Page: 18 / 24

18
4. Dog-GPS: set-up
4.1 Installing the SIM-card in the device
Before installing the SIM-card in the device, it
should be made sure that the SIM-card lock is
disabled.
Insert the SIM-card intended for the device into
a mobile phone and go to the security settings
in order to disable the SIM-card lock. For more
detailed information, see the manual for your mobile
phone.
It is also recommended to have the SIM-card in a
mobile phone for a few moments in order to make
sure that the card is functioning normally and
that you receive any settings related messages
from your service provider. Delete any received
messages before installing the SIM-card in the
device.
NOTE! The SIM-card used in the device must be
able to send/receive text messages and if you plan
to use data tracking, the SIM-card should also have
the possibility of using mobile data.
In order to install the SIM-card, open the SIM-card
cover with the Allen key supplied with the device.
After removing the screws you can ease the cover
open using the beveled part at the top of the cover.
Insert the SIM-card in the manner shown on the
illustration. Holding the collar horizontally with the
antenna pointing to your left, the chip of the SIM-
card should face upwards and the cut corner of the
SIM-card should be on the left. Push the card into
its slot carefully in a straight line. When the card is
installed correctly, the rear edge of the SIM-card will
be at the same depth as the connector above it.
Start position
At the start position the SIM-
card will slide into its slot in a
direct line.
End position
At the end position the SIM-card
will placed be at the same depth
as the connector above it.
Afterwards, install the SIM-card cover back into its
place. Install the cover evenly against the seal to
prevent twisting the seal. Press the cover down with
your thumb and tighten the screws with the Allen
key supplied with the device. Tighten the screws
carefully, but do not use excessive force in doing so.
4.2 Installing batteries
Remove the cover of the battery compartment by
twisting the thumbscrew and place 2 or 4 size 1,2V
AA batteries into the battery compartment. Take
note of the (+) and (–) –on the batteries and the
battery compartment.
NOTE! Recharge the batteries before installing
them into the device.
Install the batteries in the manner presented in the
illustration.
Two battery model
As seen from the direction
of the buc kle
Negative (-) on the left side and
positive (+) on the right side.
Four battery model
As seen fr om the direction
of the buckle
Negative (-) on the left side and
positive (+) on the right side.
Close the battery compartment cover by screwing
the thumb screw and tightening it carefully. Do not
use any tools in tightening or un-tightening the
thumb screw.
4.3 Explanation for the LED-lights
Starting up the device
After installing the batteries and closing the battery
compartment cover, take the device outside so
that it will have an unobscured field of view of the