27
FOAM 0.0A 19.87V
RUN 001:48 0.0W
FOAM 0.0A 19.87V
STOP000:00 0.0W
6>Hot Wire Foam
Cutter DRV --->
FOAM CUT 30min
2.0A 12.00V
6>Hot Wire Foam Cutter Drive
In this mode,the charger acts as a convenient power supply for a hot wire foam cutter.
The value on the right side of the first line sets the test duration in minutes.The second line
shows the upper limit of current on the left side and drive voltage on the right.After setting
the current and voltage press”Start/Enter”for more than 3 seconds to start the next
process.A beep tone will be sound.(Running time:0-90min,Current:0.1-20A,Voltage:1-40V)
Stauts display.The top line shows the foam cut current and voltage.The second line shows
the status and in the lower right comer alternately displays the output power or tatal run
time.
You can stop the test at any time by pressing”Start/Enter”.
7> Check ESC/Motor PPM and BL Motor RPM
The
G6AC+
incorporates,as the first charger,a fantastic feature which allows you
to check your brushless motors sensors and even measure motor RPM! In
combination with the built-in receiver simulator port you can even speed-controls
for correct function.The receiver simulator port also allows the check of servo’s.
Press”Start/Enter”button,then press" DEC"or"INC ".After setting the max.signal
and max.signal,press”Start/Enter”for more than 3 seconds to start the next process.
Min. Pules width (range:700~1500us) Max. Pules width (range:1500~2300us)
GHARGER PRO-8
Summary of Contents for GHARGER PRO-8
Page 1: ...GHARGER PRO 8...
