Ulthera DeepSEE DS 4 - 4.5, Instructions For Use Manual

Page: 51 / 72

Ulthera, Inc. Page
51
7.3.3. Select a transducer:
The Ulthera System has six types of transducers:
Table 7.5 Types of Transducers
TRANSDUCER SPECIFICATIONS
DS 10 – 1.5 Low energy lev el and 1.5 mm focal depth.
DS 10 – 1.5N
Low energy lev el, 1.5 mm focal depth, and a narrower contact area
than the DS 10 – 1.5.
DS 7 – 3.0 Low energy lev el and 3.0 mm focal depth.
DS 7 – 3.0N
Low energy lev el, 3.0 mm focal depth, and a narrower contact area
than the DS 7 – 3.0.
DS 7 – 4.5 Intermediate energy lev el and 4.5 mm focal depth.
DS 4 – 4.5 High energy lev el and 4.5 mm focal depth.
1. Check the expiration date on the transducer package.
2. Open the sealed pouch.
3. Connect the transducer to the handpiece by sliding the transducer into
the handpiece until the passive latch locks into place.
Figure 7.7 Connecting the Transducer
A tone will sound when the transducer has been correctly inserted. The
Treatment Guideline area on the
DeepSEE screen will display the regions
available for treatment with the inserted transducer.
Caution: If a warning or caution message is displayed, or a message
that says “Transducer Not Connected,” disconnect and reconnect the
transducer. If the problem persists, contact your Ulthera representative.
Caution: If the handpiece or transducer is dropped or broken, or any
part of the system is damaged, disconnect the system from the power
source outlet before touching any other part of the equipment.
Thoroughly inspect the equipment for external damage before
reconnecting. Do not use a damaged handpiece or transducer.