
-2- USE INSTRUCTIONS TFS 100
30/38
-
Weekly
cleaning of the heating and welding plates of the cutting devices. Do not
use metallic elements. Open mould and clean impurities or stuck material on the
plates.
-
Every six months or before end of season
, external and internal general
cleaning and lubrication of the machine. Be very careful with fasteners, cuttings,
conveyor belt and guides, vacuum valves, moulds, tefloned plates (teflon them if
necessary), vacuum pump (oil and air filters...), etc.
-
Weekly
conveyor lubrication. Before you do so, be sure that the conveyor is
clean. Lubricate the chain without film.
-To sweep the environment and low parts of the machine
daily
.
7.3 LUBRICATION
Some machine components need to be lubricated both for optimum operation
and to extend their useful life (machine and components).
Greasing shall be done manually at the points indicated in section 5.2
(Lubrication Points). Depending on the machine model, it may have the following
options:
-Chain cleaning and greasing option
-Centralized gr chain cleaning and greasing option.
Summary of Contents for TFS100
