Ulma TFS100, Manual, Page: 45 / 85

-2- USE INSTRUCTIONS TFS 100
29/38
-WEEKLY:
-Check fittings and corresponding silicone joints.
-Check duct joints. Check hoses.
-Check knifes in cutting devices. Replace them if necessary.
-Check the security circuit. When you eliminate protection devices, machine must
stop.
-Check emergency system.
-Bleed water and air filters.
-MONTHLY-QUARTERLY:
-Check conveyor tension. Increase it if necessary.
-Check if fitting lifter cylinders are working properly and lubricate fitting lifter
guides.
-Lubricate conveyor belt (use alimentary oil).
-Lubricate cross-cutting columns and film remain cutting guides.
-Compressor maintenance
-HALF-YEARLY – ANNUAL:
-Lubricate mould-holder’s ball and socket joints.
-Change defective transport grips
-Visual control of the electrical cabinet
-Change air filters of admission and expulsion (if proceed).
-Change oil filter of vacuum pump (if proceed).
When working in a corrosive environment (moisture, salt, vinegar, dairy
products, etc.), some maintenance and working standards must be observed
which depend on the mentioned environmental conditions.
During handling, avoid direct contact with water, salt, vinegar, dairy
products, etc. with the machine or film, except with the thermoformed cavity
which will contain the product (and will later be sealed).
- Daily external general cleaning of the machine with water and soap.
- At the end of each working day , film-free conveyor belt cleaning with
compressed air.
- Weekly cleaning of the air filter in vacuum pump with compressed air.
WORKING CONDITIONS IN A CORROSIVE ENVIRONMENT
MAINTENANCE IN A CORROSIVE ENVIRONMENT