------------------------------------------------------------------------------------------------------------------------
ULB PROPRIETARY RIGHTS NOTICE
- This document contains the confidential and proprietary information of ULB. You may not
possess, use, copy or disclose this document or any information in it for any purpose without express written permission. Neither receipt
from any source, nor possession of this document, constitutes such permission. Possession, use, copying or disclosure by anyone
without express written permission of ULB is not authorized and may result in criminal and/or civil liability.
C:\Users\Service-Eng\Desktop\Mx\Manuals\ULB-R110 MANUAL_rev02.docx Page
25
of
42
Software set up
Each load bank must be correcting configured using load bank settings screen shown
below. Refer maintenance section below to know how to access this screen on the display.
1) Each Load bank should have unique ID (anywhere from 1~16) assigned.
2) The “First load bank in the network (designated as Master load) bank should have
the lowest ID e.g ID=1 if other slave load banks in network have ID = 2,3,4,5 i.e
Slave 1(ID=2) , Slave 2(ID=3), Slave 3(ID=4) and Slave 4(ID=5).
3) See maintenance section below to know / set ID or Master / Slave mode for the load
bank in the load bank settings’ screen.(see figure-12)
Figure-12 Load bank settings
Master (First Load bank in the series) should have following settings in above screen,
THIS LOAD BANK TO OPERATE AS “MASTER”
THIS LOAD BANK ID
1
(Tip: lowest number in the network)
ID OF SLAVE 1 LOAD BANK
2
(Tip: Next higher number from Master Load bank ID)
Slave 1 (Next to Master Load bank) should have following settings in above screen,
THIS LOAD BANK TO OPERATE AS “SLAVE”
THIS LOAD BANK ID
2
(Tip: Next higher number from Master Load bank ID)
ID OF SLAVE 1 LOAD BANK
Not applicable
