UEi PowerDAQ PDXI-AO Series, User Manual

Page: 49 / 69

Chapter 5: Interconnections
41
Figure 10: Configuring the PD2-AO-STP with PD2-AO-8[16][32]
PowerDAQ II Analog Output Board
(8/ 1 6/32 Channels)
Channels 0- 1 5 and digital lines
Channels 1 6-3 1
PD-CBL-37
PD-AO-STP-32
Screw Terminal
IRQx and
TMRx
termination
jumpers
Local
/Remote
Sense
jumpers
AOUTx
SNSx
AOUTx – channel x output
SNSx – channel x sense line
or AGND (see jumpers JP
1 -
JP32 settings)
Jumpers JP 1 -JP32 defines the sense configuration for the
channels 0..3 1 respectively. When shunts installed at
locations B-C the channel is configured to remote sense
and SNSx terminal used to connect this line to the remote
equipment. If shunts are installed at A-B and C-D locations
the channel is configured to local sense (at screw terminal)
and SNSx terminal for the selected channel connected to
the AGND
To the servo-
motors, etc.
To/from
Digital
sensors
PD-CBL-96