7
28
Warning and Safety Instructions
This manual uses the and icons to highlight certain instructions.
Below is an explanation of the icons.
> This icon highlights special instructions and precautions intended to avoid damage
to the system. Non-compliance may void the product warranty.
Attention
> Please read through the operating instructions to understand how to operate the system,
in particular the safety instructions.
Attention
> This icon provides precautions important to prevent injuries to the user.
Warning
Warning
> Please note that there are some countries that by law disallow the rider to set the
helmet communicator to a volume that prevents you from perceiving the
surrounding.
> Please note that in some countries the use of both speakers simultaneously is
authorized only out of pubic traffic conditions.
> Please check with the relevant authorities for local safety legislation before using the
helmet communicator on the road.
> Please learn how to use the buttons by looking into the mirror before using the
helmet communicator on the road.
Notices
Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the
following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. End user must follow the specific operating instructions for satisfying RF
exposure compliance. This transmitter must not be co-located or operating in conjunction
with any other antenna or transmitter.
The portable device is designed to meet the requirements for exposure to radio waves
established by the Federal Communications Commission (USA). These requirements set
a SAR limit of 1.6 W/kg averaged over one gram of tissue. The highest SAR value reported
under this standard during product certification for use when properly worn on the body is
0.178 W/kg.
EN
EN
