15
20
General Operations
Charging the Unit
• To charge the helmet communicator, connect the provided charging cable to the speaker/
charging socket. Upon charging, if the unit is on, the system will automatically initiate
power down.
Volume Control
• The volume control of the helmet communicator can be controlled using the Up and
Down buttons. Pressing the Up or Down button will increase the volume respectively.
The volume control for each mode is independent of each other.
Automatic Speaker Loudness (Communication only)
• The speaker loudness will be automatically adjusted depending on the environment
noise level. However you can still adjust the volume manually.
Automatic Pairing
• The helmet communicator has the ability to connect to the last paired device automatically
for two features
- music and mobile phone.
• Automatic pairing of the helmet communicator with music devices is dependent on the
music devices.
Automatic Profile Switch
• The helmet communicator supports multiple profiles concurrently, but at any point of time
only one profile is active. The automatic profile switch determines which profile should be
active at any point of time starting from the highest priority: (1) Mobile Phone functions
(2) Intercom functions and (3) Music functions.
• The helmet communicator can be paired to more than 1 device.
Intercom Operations
Two-Party Intercom
To use the intercom for the first time, you must pair your communictor to another
HBC220 SNOW unit.
Pairing process needs to be carried out only once.
Pairing
•With both helmet communicators powered off, hold for 3 seconds Answer and Down
buttons on one unit releasing when you see a red light. Then hold Answer and Up
buttons on the other releasing when you see red light. The indicators of both
helmets would blink purple.
•When both of the communicator’s status indicator turns blue, the pairing process is
successful.
It is recommended to restart the devices after the pairing process.
Start Intercom
To enable the intercom, hold the Up button for 2 seconds.
Stop Intercom
To disable the intercom, hold the Down button for 2 seconds.
Helmet 1
( 1st device)
Hold Answer and Down Button
Helmet 2
( 2nd device)
Hold Answer and Up Button
EN
EN