UCL SWIFT TEK-3, Training Manual

Page: 13 / 29

PAGE 2
3330 Earhart Drive, Suite 208
|
Carrollton, TX 75006
|
Office: 972.556.0916
|
Fax: 972.910.8384
OPM1
WARNING
Read and understand all of the instructions and safety information in this manual before
operating this tool.
!
ELECTRIC SHOCK HAZARD
Contact with live circuits could result in severe injury or death. Pay attention to proper battery polarity.
Do not mix battery types or manufacturers. Do not open the unit. Use this unit only for its intended
purpose as outlined in this guide.
!
WAVELENGTH BUTTON
dB/dBm BUTTON
POWER BUTTON
9
10
11
Hold the button to switch the OPM1 between the 850, 1300, 1310,
1490, 1550, 1611, and 1625nm wavelengths. Press the button once to
immediately display the current wavelength. The selected wavelength
will briefly appear on-screen every 8 seconds.
Press the button to toggle between dB and dBm modes. Hold the button
down when in dBm mode to set a reference on the OPM1.
Press the button once to turn the OPM1 on. Press once again to turn the
OPM1 off. The OPM1 will automatically turn off after 5 minutes if inactive.
LASER HAZARD
Avoid eye exposure to open fiber connectors and interfaces when working with fiber systems. They
may be connected to a live laser source. Do not look into the output port of a laser source. Point
fiber endfaces toward non-reflective surfaces to prevent reflection of laser.
!
ITEM DAMAGE HAZARD
Do not leave the item in direct sunlight or near heat sources, submerge in water, or subject the unit
to strong impact. Cover the fiber interface with the flip-cap when the unit is not in use.
!
DO NOT THROW THIS PRODUCT AWAY
Contact your local recycling station to dispose of properly.
!
IMPORTANT SAFETY INFORMATION