60
[Editable parameters in mode]
Parameters
Description
Normal
mode
User
mode
Fiber type
The splice modes saved in the database
are displayed. The mode selected by the
user is copied to the splice mode in the
user side program.
Non
Editable
Editable
Mode title 1
The title can be composed of 1 to 11
characters.
Mode title 2
It consists of up to 11 characters and is
used to provide more detailed information.
It can be found in the [Splice Mode] menu.
Align
It is used to set the fiber arrangement
methods.
“Auto”: Fibers are aligned to the center
position automatically.
“Manual”: Fibers are aligned directly with
motor control.
Offset Limit
(Align)
It sets the offset range of each fiber when
aligning the fibers.
Cleave Limit
It sets the tolerance range of cleave angle.
An error message appears when a
measured right, left or both angles exceed
the range.
Gap Difference
Limit
It estimates the gaps of the corresponding
fibers.
An error message appears when the
deviation of the gap is greater than the
maximum range.
Loss Limit
It sets the error range of estimated loss.
An error message appears when the
estimated loss is greater than the
maximum range.
Summary of Contents for KR12A
