Ubisys G1, Assembly And Commissioning Instructions

Page: 17 / 51

17 Gateway G1
Section 3 | Gateway G1 Configuration
New devices can currently be connected with your Smart
Home System. An access code for adding a new control device has been enabled
via the web interface. To activate a control device in your Smart
Home System, enter this code on the device that shall be added.
The device (iPhone Doe) is now having access to your Smart
Home System. Access to your Smart Home System has been successfully gran-
ted to the new control device.
The device (iPhone Doe) has no access to your Smart Home
System. Access to your Smart Home System is from now on restricted for
the appropriate device. Reactivating access is only possible by a
new access code.
The update of the network component with the IEEE address
(IEEE address: 00:1F:EE:00:00:00:00:01) has been success-
fully completed. A new firmware for a Smart Home component has been downloa-
ded and will be installed afterwards. After successful installation,
the component restarts and will then be available again.
Warning messages (orange highlighted)
Content Explanation
A command directed to the component (network address
1234) failed (status code: NWK:ROUTE_ERROR).
This error may occur, if the component is temporarily not
available.
If the error is not patched automatically after some time,
contact the support (http://www.ubisys.de/smarthome/support.
html). This is usually a temporary radio transmission interference in your
Smart Home System, wherein control commands cannot be sent
to the target device.
This kind of error is often caused by external parasitic induction
and will be automatically fixed by the intelligent radio standard
being used.
If this warning message is displayed repeatedly, check, if the
affected component is installed and properly connected to power.
Do the same for temporarily stored ZigBee routers.
A command directed to the group (group address 0001) failed
(status code: MAC:CHANNEL_ACCESS_
FAILURE).
This error may occur, if the component is temporarily not
available.
If the error is not patched automatically after some time,
contact the support (http://www.ubisys.de/smarthome/support.
html). This is usually a temporary interference or overload in the ZigBee
network, wherein control commands cannot be sent to a group of
controlling devices.
This kind of error is often caused by external parasitic induction or
massive radio traffic and will be automatically fixed by the intelli-
gent radio standard being used.
A command directed to the network address (broadcast
address: fffd) failed (status code: MAC:CHANNEL_ACCESS_
FAILURE).
This error may occur, if the component is temporarily not
available.
If the error is not patched automatically after some time,
contact the support (http://www.ubisys.de/smarthome/support.
html). This is usually a temporary radio transmission interference in your
Smart Home System, wherein control commands cannot be sent
to the target device.
This kind of error is often caused by external parasitic induction
and will be automatically fixed by the intelligent radio standard
being used.
If this warning message is displayed repeatedly, contact the ubisys
support.
Your Smart Home System denied access to the unauthorized
device 192.168.0.111. Authentication of a device has failed during the login attempt. This
is usually a mobile device, which had access to your Smart Home
System.
The update of the network component with the IEEE address:
00:1F:EE:00:00:00:00:01 has failed. Further attempts will
follow. The download of the new firmware for the appropriate Smart
Home component has been interrupted due to transmission inter-
ferences or a power breakdown, for example.
Another attempt will be done automatically.
An update could not be performed. Further attempts will follow. A Smart Home component has prematurely cancelled the
download attempt of a new firmware. A new attempt will be done
automatically.