USER GUIDE
u-line.com
General Installation
Connections
When complete, the connections should look like this:
LEVELING INFORMATION
1.
Use a level to confirm the
unit is level. Level should
be placed along top edge
and side edge as shown.
2. If the unit is not level,
shim as needed.
3.
Confirm the unit is level
after each adjustment
and repeat the previous
steps until the unit is
level
.
To CO2
Source
Two CO2 Lines
CAUTION
!
To comply with applicable federal, state,
and local codes, it may be necessary to
caulk the refrigerator to the floor.
CASTERS (optional)
1. Remove grille and back panel to access nuts.
2. Remove each nut and unscrew each leg.
3. Install each caster and secure with nut.
Tighten with included wrench.
4. Replace grille and back panel.
When ready to use, see FIRST USE section in
this manual.
To Nitrogen
Source
1/6 Slim
Barrel
1/4 Slim
Barrel
Infuser
Regulator
Alternate infuser regulator setup
Two CO
2
lines and One Nitrogen line
Standard infuser regulator setup
One CO
2
line and Two Nitrogen lines
Standard
Ball-tap Keg
Filter
Assembly
One Nitrogen
Line
19
