SAFETY •
INSTALLATION & INTEGRATION
• OPERATING INSTRUCTIONS • MAINTENANCE • SERVICE
USER GUIDE
u-line.com
Grille - Plinth Installation 1
Door Stop
Your U-Line unit was shipped to you with the optional
90° pin.
Your unit’s door(s) will open 115° straight from the
factory. If you would like the door stop at 90° follow
these instructions.
NOTICE
If your unit is already undercounter, it will need
to be moved out to access the hinge. With the
90° stop pin in place, you will not be able to
replace the hinge cover.
1.
Open door approximately 90°.
2.
Remove hinge cover by lifting top and bottom of
hinge cover and sliding the cover inwards to
remove from hinge.
3.
Once cover is removed, slide hinge pin into hole as
shown. Pin should slide into place, stopping the
door at 90°; if the pin does not go into the hole
shown, hold the door less than 90° open and try
again.
4.
To fully seat the pin, tap it lightly with a hammer.
5.
Carefully slide your unit back in place.
NOTICE
The pin can be removed to return the door swing
back to its original 115° swing by tapping the
pin out from the bottom of the hinge.
CLOSER
The door hinge has a self-closing feature that
engages when the door is open approximately 6"
(150 mm) (about 25°).
Door Stop 1