TYROLIT Hydrostress AGE125, Operating Instructions Manual

Page: 18 / 178

TYROLIT
18 AGE125
For your safety
WARNING!
Before using the angle grinder, please read
and follow:
– these operating instructions,
–
the “General safety instructions” on the
handling of power tools in the enclosed
booklet (leaflet-no.: 11003025),
–
the currently valid site rules and the
regulations for the prevention of
accidents.
This angle grinder is state of the art and has
been constructed in accordance with the
acknowledged safety regulations.
Nevertheless, when in use, the power tool
may be a danger to life and limb of the user
or a third party, or the power tool or other
property may be damaged. The angle
grinder may be operated only if it is
– as intended,
–
in perfect working order.
Faults which impair safety must be repaired
immediately.
Intended use
This angle grinder
– for commercial use in industry and trade,
– is designed for dry grinding and cutting
metal and stone; a special cutting guard
must be used for cutting,
– for use with grinding tools and acces-
sories which are indicated in these
instructions or recommended by the
manufacturer.
Not permitted are e.g. chain cutting wheels,
saw blades.
Safety Warnings for Angle Grinder
WARNING!
Read all safety warnings and all instruc-
tions. Failure to follow the warnings and
instructions may result in electric shock, fire
and/or serious injury. Save all warnings and
instructions for future reference.
Safety Warnings Common for Grinding
or Abrasive Cutting-Off Operations

This power tool is intended to function as
a grinder or cut-off tool. Read all safety
warnings, instructions, illustrations and
specifications provided with this power
tool. Failure to follow all instructions listed
below may result in electric shock, fire and/
or serious injury.

Operations such as sanding, wire
brushing or polishing are not recommen-
ded to be performed with this power tool.
Operations for which the power tool was
not designed may create a hazard and
cause personal injury.

Do not use accessories which are not
specifically designed and recommended
by the tool manufacturer. Just because the
accessory can be attached to your power
tool, it does not assure safe operation.

The rated speed of the accessory must be
at least equal to the maximum speed
marked on the power tool. Accessories
running faster than their rated speed can
break and fly apart.

The outside diameter and the thickness of
your accessory must be within the
capacity rating of your power tool.
Incorrectly sized accessories cannot be
adequately guarded or controlled.

Threaded mounting of accessories must
match the grinder spindle thread. For
accessories mounted by flanges, the
arbour hole of the accessory must fit the
locating diameter of the flange.
Accessories that do not match the
mounting hardware of the power tool will
run out of balance, vibrate excessively and
may cause loss of control.

Do not use a damaged accessory. Before
each use inspect the accessory such as
abrasive wheels for chips and cracks,
backing pad for cracks, tear or excess
wear, wire brush for loose or cracked
wires. If power tool or accessory is
dropped, inspect for damage or install an
undamaged accessory. After inspecting
and installing an accessory, position
yourself and bystanders away from the