Tynetec Entel Ultra, Installation Manual

Page: 14 / 44

Doc No. FM0713 Issue C Page 14
6. DOOR PANELS
6.04 BACKBOX CUT-OUT
The cut-out dimensions given below will allow the door panel backbox to fit flush into the wall or door screen.
The backbox has a stainless steel bezel which overlaps this cut-out by approx 10mm on all sides.
TYNETEC P/No. DESCRIPTION HEIGHT WIDTH DEPTH
ZSD501-508 1 to 8 Way + Trade Functional Door Panel 320mm 170mm 70mm
ZSD509-514 9 to 14 Way + Trade Functional Door Panel 415mm 170mm 70mm
ZSD521-534 1 to 14 Way + Trade + Display Functional Door Panel 415mm 170mm 70mm
ZSD590 Digital Door Panel 415mm 170mm 70mm
ZSD595 Alpha Numeric Digital Door Panel 415mm 170mm 70mm
6.05 BACKBOX INSTALLATION
All backboxes are flush mounting with a stainless steel bezel, there are 2 different backbox sizes depending on
the door panel model, see table above. All door panel fascias are fixed by 6 off M5x12mm Allen key screws
which require a 3mm Allen key tool.
The backbox should be orientated with the Earth stud/crimp
and warning label in the top left hand corner.
Do not cut a hole in the top face of the backbox for cable
entry - this may allow water to enter and damage the
electronic components or keypad.
Cable entry into the backbox should be through the side or
rear 20mm knockouts provided.
IMPORTANT: the backbox must be bonded to the Mains Earth
using 2.5 mm
2
cable.
The height above finished floor level at which the backbox is
mounted should be clarified with the Supervising Officer.
The backbox should be cut into the brick work or door screen
and sealed with suitable mastic to prevent water ingress.
6.06 SURFACE/FLUSH COWLINGS
If it is not possible to flush mount the backbox then a surface mount stainless steel cowling is available.
To provide more protection from the elements a flush cowling can be fitted to a flush mounted backbox.
DOOR PANEL RANGE SURFACE COWLING P/No. FLUSH COWLING P/No.
ZSD501-508 HM1130 HM1100
ZSD509-514 HM1140 HM1105
ZSD521-534 HM1140 HM1105
ZSD590/595 HM1140 HM1105
HOW TO FIT A SURFACE COWLING:
Remove the stainless steel bezel from the standard flush
backbox by drilling-out the rivets.
Then place the backbox (without bezel) inside the
cowling before fixing to the wall.
HOW TO FIT A FLUSH COWLING:
Simply fit the cowling around the backbox behind the
bezel before fixing the backbox flush into the wall.
Surface
Cowling
Flush
Cowling