TYM TX753, User Manual

Page: 78 / 180

2 - 28
2 - 29
DESCRIPTION OF OPERATING SYSTEM
2 - 28
2 - 29
CONTROl PANEl OF ElECTRONIC lIFT SYSTEM ►
<Overview>
The electronically controlled lift sys-
tem can provide various functions
through simple switch operations,
unlike the mechanical type, to en-
hance the driver's convenience and
efficiency. The electronically con-
trolled lift system has the following
four control modes which can be
selected with the mode button.
- Position control
- Draft control
- Plowing depth control (Optional)
- Horizontal balance control
(Optional)
Before operating the control unit,
make sure that the knobs are
adjusted to the desired positions.
Never stop and leave the tractor
with an implement lifted.
The control unit is equipped
with the self-diagnosis function
which triggers the alarm for any
found fault in the system.
•
•
•
WARNING
To prevent damage to electronic
components, keep the following
instructions when arc welding the
tractor equipped with the electron-
ic lift or an attached implement.
Separate an implement or part
to be welded from the tractor if
possible.
Disconnect the two battery
cables.
Set the welding machine's
ground clamp as close as pos-
sible to the point to be welded.
Remove the control unit first if
the welding spot is within 1 m
from the unit.
Make sure that the cable is not
close to or over any electric or
electronic lead while welding.
•
•
•
•
•
CAUTION
TX753,TX853-영문-02(나).indd 28 2014-04-23 오후 4:57:52