TYM TX753, User Manual

Page: 126 / 180

5 - 8
Maintenance and service
(2) changing
①
Unscrew the drain plugs on the
bottom of the axle and left/right
final cases to drain engine oil.
Since hot fluid flows out of the
engine first, be careful not to get
burnt.
②
after draining oil, tighten the oil
drain plug.
③
add the specified amount of the
specified oil through the filler hole.
(3) Oil specification
Gear oil SaE 90W
(aPI GL- grade or higher)
5. replacing filter
and cartridge
replacing transMissiOn
fluid filter cartridge
①
Remove the hydraulic oil filter
element by turning it counterclock-
wise with a wrench.
②
Apply a thin film of oil to the O-ring
of a new cartridge and install the
new cartridge by tightening it with
a hand. When its packing touches
the sealing surface, turn it approx.
/3 turns further with a wrench.
③
Add hydraulic oil to the specified
level.
④
Check the oil level with the dip-
stick again. If still insufficient, add
more.
►
803f00a
Transmission fluid filter
Do not add front axle oil over
the upper limit level.
Check the front axle oil before
starting the engine or at least
in 5 minutes after the engine is
stopped.
When trying to use new oil from
a different manufacturer or oil
with different viscosity, drain
used oil completely before add-
ing new oil.
•
•
•
NOTE
If oil gets on your skin, it can ir-
ritate the skin and cause a skin
condition. Make sure to clean
your skin with soap and water
or hand cleaner thoroughly.
Make sure to cool down the
engine sufficiently before drain -
ing oil. Oil is very hot and can
cause a burn if changing oil
right after the engine is stopped.
•
•
CAUTION
TX753,TX853-영문-05(마).indd 8 2014-04-05 오전 10:03:01