9 |
P a g e
OPERATING INSTRUCTIONS
–
T
WIN
E
AGLES
G
AS
P
OWER BURNER
BEFORE LIGHTING THE POWER BURNER
DO NOT ATTEMPT TO LIGHT THE POWER BURNER IF YOU SMELL GAS.
WARNING! IT IS CRITICAL THAT THE GAS BURNERS ARE PROPERLY INSTALLED WITH
THEIR ORIFICES INSIDE THE BURNERS AIR SHUTTERS. If not properly installed, gas may leak
outside of the burner that could lead to fire, potential damage to your Power Burner and bodily injury.
Inspect the gas supply piping or hose prior to turning the gas ON. If there is evidence of cuts, wear, or
abrasion, it must be replaced prior to use. The replacement pressure regulator and hose assembly must be the
type specified by the manufacturer. Do not use the Power Burner if the odor of gas is present. The pressure
regulator and hose assembly supplied with the units must be used.
If the unit is LP, screw the regulator and hand tighten to the valve of the cylinder and leak check the hose and
regulator connections with a soap and water solution before operating the Power Burner. Reference page 4
for leak test procedure.
Always keep your face and body as far away as possible when lighting.
Refer to spiders and insects warning and procedure under the cleaning and maintenance page of this manual.
Match/BBQ Lighter Lighting Instructions:
If there is no electrical power supply available or if hot surface igniter will not light the burners, the
burners can be lit manually using a lighted long match, taper or BBQ lighter.
1.
Push and turn the knob counter-clock-wise to the biggest flame marking on the bezel. Hold the
knob pushed in for 5 seconds.
2.
Insert a lit match or BBQ lighter thru the grates and near the top of the burner. Once you see
or hear a flame you can release the knob.
TO LIGHT THE POWER BURNER’S BURNER
Lighting the Power Burner
1.
Open the gas supply shut-off valve.
2.
Push in the knob and verify that the hot surface igniter glows. If the igniter does not
glow, verify for proper power supply. (Reference page 5 for electrical
requirements).
3.
Once the glowing is verified for 5 seconds simultaneously push-in and turn the
knob counter-clock-wise to the biggest flame marking on the bezel. Hold the
knob pushed in for 5 seconds. Once you see or hear a flame you can release the
knob.
CAUTION
: If ignition does not take place within 5 seconds, turn knob to the OFF
position, wait for five minutes and repeat step 3
.
Important
: If burner fails to light within 5 seconds, turn off gas and
wait 5 minutes before repeating the process.
Warning
: If you smell gas, shutoff the gas supply and immediately
check for leaks using the soapy water technique
.
