1. Plug the end of the phone cord nearest to the microphone into the ‘Accessory’ jack on the headset.
2. Plug the opposite end of the phone cord into the headphone jack of your cell phone or cordless home phone.
3. Turn on your TV Ears Professional headset.
Your phone should recognize a headphone has been plugged in. If not, set your phone to headphone mode.
Using the Music Cord:
The music cord works with stereos, CD players, MP3 players, computers, portable radios, and airplanes with
headphone jacks. The two ends of the music cord are different sizes. The smaller of the ends plugs into the
Professional headset and the larger of the two plugs into the music source.
1. Plug the smaller plug (2.5mm) into the “Accessory” jack of the Professional headset.
2. Plug the larger plug (3.5mm) into the headphone jack of your music source.
3. Set the volume of your music source between ½ and ¾ of the full volume.
4. Turn on your TV Ears Professional headset and adjust the volume to a comfortable volume for you.
The TV Ears headset receives an invisible infrared signal from the stack that is connected to the television.
Be certain that the infrared diodes located on the front of the stack are in direct sight with the front of
the headset to receive the signal. The infrared signal from the stack to the headset should be clear of any
obstruction (plants, books, furniture, etc.). The infrared signal cannot pass through walls or solid objects. The
headset can only pick up the infrared signal in the same room as the stack.
Step 2
|
Removing the Headset after use
Always use two hands to place and remove your headset from your ears. Using one hand may loosen or tug on the
bow arms and damage your headset.
1. Remove the headset from the charging cradle of the transmitter.
2. The BALANCE control is located on the back of the headset. The balance comes set
equal to both ears. To change the balance of volume to the right and left ears, insert
the balance control tool into the opening and turn the tool towards the ear you want
to increase the volume to.
3. The writing on the front of the headset should face away from your body. The
infrared signal is received on the front of the headset.
4. Using both hands, gently separate the bow arms and place earpieces into each ear
(similar to placing a stethoscope).
5. The VOLUME control will be located on the RIGHT side. Rotate the dial to turn ON
the headset and set the volume to your comfort level.
6. The TONE control (bass and treble) will be located on the LEFT side. Rotate the
dial to adjust the tone to your preference.
Using the System
Step 1
|
Using the Headset
2
10
1
8
1. Turn the headset OFF by rotating the VOLUME dial , reducing the volume until you feel or
hear a click.
2. Using both hands, gently separate the bow arms from your ears.
3. Remove the headset by lowering it under your chin.
4. Place the headset into the charging cradle of the transmitter.
1
Using the Phone Cord:
The phone cord works with most phones and most cordless home phones
that have a headphone jack. The phone cord will fit a headphone jack that
is 2.5mm. Adapters may be needed for some phones. A TV Ears Professional
headset and phone cord cannot be used while driving.
Page 6
