5
FP8K-B / FP8K-DX / FP8K-DX-XLT
Jun 2017-A
TOOLS REQUIRED
Ø
Set of Metric Wrenches and/or Sockets
Ø
Adjustable Wrench
Ø
Locking Pliers
Ø
25
’ Tape Measure
Ø
Step Ladder
Ø
Hammer
Ø
Crow Bar
Ø
4 Foot Level
Ø
Chalk Line
Ø
Flat Screwdriver
Ø
Hex-Key / Allen Wrench Set
Ø
Needle Nose Pliers
Ø
Rotary Hammer Drill (If anchoring)
Ø
3/4" Masonry Bit (If anchoring)
Ø
3 Gallons of Hydraulic Oil*
*Recommended Oil: ISO 32 Light Hydraulic Oil
SELECTING SITE
Before installing your new lift, check the following.
OVERHEAD OBSTRUCTIONS:
The area where the lift will be located should be free of overhead
obstructions such as heaters, building supports, electrical lines etc.
FLOOR REQUIREMENTS:
Visually inspect the site where the lift is to be installed and check for cracked or
defective concrete. This lift must be installed on a solid level concrete floor with no more than 2 degrees of
slope. A level floor is suggested for proper installation and level lifting. If a floor is of questionable slope,
consider a survey of the site and/or the possibility of pouring a new level concrete slab. This lift is designed to
be installed on a minimum of 4-1/4
”" thick, 3000psi, with steel reinforced concrete. Do not install this lift on
asphalt, wood, or any other surface other than described. This lift is only as strong as the foundation on which
it is installed.
NOTE: This Lift does not require bolting to the floor (BUT) If you choose the option to anchor the Lift to
the floor, please follow the detailed instructions in the manual and criteria above. (See page 16)
DO NOT
install this lift outdoors unless special consideration has been made to protect the power unit from
weather conditions.
The Power unit is not water proof!
DO NOT
install lift close to wall. It is necessary to leave adequate clearance for safe movement around lift.
Suggested clearance to be 1 meter (3 feet) at minimum.
OPERATING CONDITIONS:
Lift is not intended for outdoor use and has an operating ambient temperature
range of 41º-104ºF (5º-40ºC).
Summary of Contents for FP8K-B
