2
FP8K-B / FP8K-DX / FP8K-DX-XLT
Jun 2017-A
READ THIS MANUAL THOROUGHLY BEFORE INSTALLING, OPERATING, OR MAINTAINING THIS LIFT.
WHEN DONE WITH INSTALLATION BE SURE TO RETURN DOCUMENTS TO PACKAGE AND GIVE ALL
MATERIALS TO LIFT OWNER/OPERATOR. WHEN INSTALLATION IS COMPLETE BE SURE TO RUN
LIFT UP AND DOWN A FEW CYCLES WITH AND WITHOUT “TYPICAL” VEHICLE LOADED ON LIFT.
TABLE OF CONTENTS
• IMPORTANT INFORMATION
• OWNER / EMPLOYER RESPONSIBILITY
• LIFT SPECIFICATIONS
• FLOOR PLAN LAYOUT
• TOOLS REQUIRED
• SELECTING SITE
• MAIN COMPONENTS & ACCESSORY IDENTIFICATION
• INSTALLATION INSTRUCTIONS
• CASTER KIT ASSEMBLY / INSTALLATION
• FOUNDATION & ANCHORING REQUIREMENTS
• SAFETY INSTRUCTIONS & PROCEDURES
• OPERATION INSTRUCTIONS
• PREVENTIVE MAINTENANCE SCHEDULE
• TROUBLESHOOTING
• POWER UNIT PRIMING PROCEDURE
• LATCH & CABLE INSPECTION / ADJUSTMENTS
• EXPLODED VIEWS
• PARTS LIST
• WARRANTY POLICY
IMPORTANT INFORMATION
1. Always inspect the lift for damage and make note of any damage on the bill of lading.
2. In case of freight damage, call the truck line immediately and report the damage as a freight claim.
3. IMPORTANT! Make sure you have extra help or heavy duty lifting equipment when unloading and
assembling the lift.
4. Please read the safety procedures and operating instructions in this manual before operating lift. Keep
this manual near lift at all times. Make sure all operators read this manual.
5. IMPORTANT! Are you installing in a level location? (Lift must be anchored in place if slope is greater
than 1/8” per foot.)
6. Make sure you have enough room to install the lock rods. You will need at least 6
’ of clearance from the
opposite end of the power unit end of the lift and 6
’ at the power unit end. The power unit may be
installed on the driver front or the passenger rear corner.
7. Never raise a car until you have double checked all bolts, nuts and hose fittings.
8. Always lower the lift to locks before going under the vehicle or storing another vehicle underneath lift.
9. Never allow anyone to go under the lift when raising or lowering.
OWNER / EMPLOYER RESPONSIBILITY
This is a vehicle lift installation/operation manual and no attempt is made or implied herein to instruct the user
in lifting methods particular to an individual application. Rather, the contents of this manual are intended as a
basis for operation and maintenance of the unit as it stands alone or as it is intended and anticipated to be
used in conjunction with other equipment.
Proper application of the equipment described herein is limited to the parameters detailed in the specifications
and the uses set forth in the descriptive passages. Any other proposed application of this equipment should be
documented and submitted in writing to the factory for examination. The user assumes full responsibility for
any equipment damage, personal injury, or alteration of the equipment described in this manual or any
subsequent damages.
Summary of Contents for FP8K-B
