Tuthill KINNEY 850D, Operator'S Manual

Page: 26 / 38

26
13. Place the cam keys in the shaft grooves and tap the outer cam onto the shaft with the threaded holes
of the cam outward.
14. Place the open head slide-pin on the piston slide with the flat edge toward the piston and insert the
piston and slidepin into the cylinder with the inlet ports of the piston facing down.
15. Install the open head the same as the closed head.
16. Slip the backup ring on the shaft and install the rotating part of the shaft seal.
17. Press the stationary part of the shaft seal in the bearing housing. Install the bearing on the shaft and
Into the housing and replace the lock nut on the shaft.
18. Install the discharge valves. Replace the valve deck cover and air/oil baffle assembly.
19. Install the separator housing and gasket.
20. Replace the oil sight gauge and replace the separator housing cover and gasket.
21. Replace the housing and oil circulating pump. Replace all oil lines and components.
22. Replace the motor and sheaves.
23. Replace and tension the V-belts and install the belt guard.
24. Reach through the suction port and pour 4 quarts (2 liters) of oil on the slide-pins and finish filling the
pump with oil.
25. Connect the electrical, water and manifolding connections to the pump.
26. Run the pump and test that the pump can obtain satisfactory ultimate pressure.