13
SETUP AND ASSEMBLY
Step 22.
Route the Control Box Wiring Harness along
the top of the tongue. Secure to the top of the tongue
with two black plastic tie wraps. Provide enough
slack in the cable next to the hitch to avoid binding
or pinching the cable during sharp turns.
Step 23.
Check for proper operation of the jack stand.
The jack stand should swivel and lock securely into
position.
INSTALLING THE OPTIONAL 5TH WHEEL HITCH
ASSEMBLY
(See Figure 8)
Step 20.
Remove and discard the rubber grommet in
the hitch assembly.
Step 21.
Insert the tongue and hitch assembly into the
front of the 1530 frame. Attach the tongue to the
frame with two 1/2” x 4-1/2” hex head screws, 1/2”
lock washers and 1/2” hex nuts.
1/2" X 4-1/2" LONG HEX HEAD
SCREW WITH 1/2" LOCK WASHERS
AND 1/2" HEX NUTS
FIGURE 8
OPTIONAL 5TH
WHEEL HITCH
ASSEMBLY
JACKSTAND
REMOVE AND
DISCARD RUBBER
GROMMET
PLASTIC TIE WRAPS FOR
CONTROL BOX CABLE HARNESS
AS85804-07
