Tufline MVT1710, Operator'S Manual, Page: 22 / 50

Dealer Instructions 19
Figure 1
Set of Lower Hitch
Bushings for iMatch
(Sold Separately)
Safety Light Assembly MVT(cont'd)
MVT Safety Light Assembly
Figure 2
Begin assembling the wire harness from the
front of the unit. Plug the harness extension
(Ref.2 Figure 2) to the tractor connector (Ref.
1). Lay the harness extension around the right
side of the unit as shown in Figure 2. Connect
the harness extension (Ref.2) to the light con-
trol module (Ref. 3) with the holes on the
mainframe. Insert 1/4" screws into the two
holes and tighten. Connect the Y harness
(Ref. 4) to the light control module (Ref. 3).
Attach the short end of the Y harness (Ref. 4)
into the closest light fixture (Ref. 5). Attach the
long end of the Y harness (Ref. 4) into the fur-
thest light fixture (Ref. 5). Hook up the front of the
light harness to a tractor and check that all lights
are working properly.
Use cable ties to attach the light harness to the
mainframe. Be careful about pinch points and
rubbing areas of machine surfaces that might
damage the wiring. Allow room from the front of
the mainframe to the tractor for right and left turn-
ing radius.