Tufline MVT1710, Operator'S Manual, Page: 13 / 50

Dealer Instructions 10
Pre-Assembly cont'd on page 11
band from the two remaining wheel & spindle
assemblies on pallet (Ref. 1, Photo 7). Insert
the spindle into the wheel carriage where the
wheel carriage extensions were removed. Line
up the hole in the spindle and wheel carriage
and insert the 3/8” x 3” Gr. 5 bolt removed in an
earlier step (Ref. 1, Photo 8). Repeat the same
steps for the three remaining wheels. Once
complete, tighten nuts accordingly. Please see
(Photo 3). Remove the two 7/8” x 6 ½” Gr. 5
bolts (Ref. 1 & 2, Photo 4) which connect the
tongue to the frame and pallet. Do not discard
these bolts. They will be used to connect the
tongue to the frame later in the set up. Lay the
tongue assembly (284 lbs) on the ground
(Photo 5). Using the overhead hoist, raise the
frame until pressure has been removed from
the wheels. Remove the wheel extensions (Ref.
1, Photo 6) from the wheel carriage by remov-
ing the 3/8” x 3” Gr. 5 bolt (Ref. 2, Photo 6). Do
not discard 3/8” x 3” Gr. 5 bolts, they will be
used again to reapply the wheel & spindle
assembly to wheel carriage. Also, remove the
3/8” x 3” Gr. 5 bolt holding the wheel & spindle
assembly to the wheel carriage extensions
(Ref. 3, Photo 6). Once both wheel carriage
extensions have been removed, discard both,
as they are for shipping purposes only. Cut
Photo 6
Photo 7
Photo 8
Photo 9
Photo 10
2
1
3
1
1
1