FIG. 11
Using a rubber mallet, insert four Plastic End Caps 2 X 3
(#59) onto the tube-ends of the
Main Frame (#30)
. Next, attach the
two
Pivot Axles (#41)
, the
Cam Support Tube (#34)
, and the
Ad-
justable Cam (#33)
to the
Main Frame (#30)
.
Note:
Refer to the Exploded View Diagram on fold-out page 11
for further illustration of this assembly.
FIG. 9
Route the
Cable (#49)
through the
Bottom Cross Brace
(#37)
tube, as shown above.
FIG. 10
Affix the
Weight Shroud w/Plate (#3)
to the bottom of the
Weight Stack Frame (#1)
and at the top of the
Guide Rod Retainer
(#5)
using four Hex Head Cap Screws 1/4-20 X 3/4 (#21), and four
Flat Washers 1/4” (#20).
Loosely Fasten:
Do not completely fasten this hardware as-
sembly at this time, as it will be completely fastened later in
the assembly process.
Owner’s Manual: Assembly Instructions
4
37
49
3
5
1
SP-415 Inner/Outer Thigh
FIG. 12
Attach the
Left Leg Arm (#32)
to the corresponding
Pivot
Axle (#41)
, repeat the procedure for the
Right Leg Arm (#31).
Note:
Refer to the Exploded View Diagram on fold-out page 11
for further illustration of this assembly.
41
33
34
41
30
59
59
59
59
41
31
32
30
41