SWPSYNC <cpd>
Set the sweep sync <ON> or <OFF>.
SWPTIME <nrf>
Set the sweep time to <nrf> sec.
SWPTYPE <cpd>
Set ten sweep type to <CONT>, <TRIG>, <THLDRST> or <MANUAL>.
SYNCOUT <cpd>
Set the sync output <ON>, <OFF>, <AUTO>, <WFMSYNC>,
<POSNMKR>, <BSTDONE>, <SEQSYNC>, <TRIGGER>, <SWPTRG>
or <PHASLOC>.
TONEEND <nrf>
Delete tone frequency number <nrf> thus defining the end of the list.
TONEFREQ <nrf1>,<nrf2>
Set tone frequency number <nrf1> to <nrf2> Hz.
TRIGIN <cpd>
Set the trig input to <INT>, <EXT>, <MAN>, <POS> or <NEG>.
TRIGPER <nrf>
Set the internal trigger generator period to <nrf> sec.
VCAIN <cpd>
Set the vca/sum input to <VCA>, <SUM> or <OFF>.
WAVE <cpd>
Select the output waveform as <SINE>, <SQUARE>, <TRIANG>, <DC>,
<POSRMP>, <NEGRMP>, <COSINE>, <HAVSIN>, <HAVCOS>,
<SINC>, <PULSE>, <PULSTRN>, <ARB> or <SEQ>.
WAVFREQ <nrf>
Set the waveform frequency to <nrf> Hz.
WAVPER <nrf>
Set the waveform period to <nrf> sec.
ZLOAD <cpd>
Set the output load, which the generator is to assume for amplitude and
dc offset entries, to <50> (50
Ω
), <600> (600
Ω
) or <OPEN>.
Refer to Calibration section for remote calibration commands.
Maintenance
The Manufacturers or their agents overseas will provide a repair service for any unit developing a
fault. Where owners wish to undertake their own maintenance work, this should only be done by
skilled personnel in conjunction with the service manual which may be purchased directly from
the Manufacturers or their agents overseas.
Cleaning
If the instrument requires cleaning use a cloth that is only lightly dampened with water or a mild
detergent.
WARNING! TO AVOID ELECTRIC SHOCK, OR DAMAGE TO THE INSTRUMENT, NEVER
ALLOW WATER TO GET INSIDE THE CASE. TO AVOID DAMAGE TO THE CASE NEVER
CLEAN WITH SOLVENTS.
82