Waveform Offset
Pressing the
wave offset
soft-key calls the
WAVE OFFSET
screen.
WAVE OFFSET: +0000
♦
◊
start: 00400
◊
stop: 01000 undo
◊
◊
exit save
◊
The waveform offset can be changed on a section of the waveform defined by the
start
and
stop
addresses. Set the addresses by pressing the appropriate soft-key and making entries
directly from the keyboard or by rotary control.
The data values over the specified section of the waveform are offset by the value entered in the
WAVE OFFSET
field. Press the appropriate soft-key and make entries direct from the keyboard or
by using rotary control. Entries in the range -4096 to +4095 will be accepted; this permits, in the
extreme, waveform sections with values at the -2048 limit to be offset to the opposite limit of
+2047. Warnings are given when the offset causes clipping but the entry is still accepted.
The original waveform can be restored by pressing the
undo
soft-key. When the offset has been
modified as required the new waveform can be saved by pressing the
save
soft-key; pressing
exit
returns to the
EDIT FUNCTIONS
screen without change.
Wave Invert
Pressing the
wave invert
soft-key calls the
INVERT
screen:
INVERT: wv02
♦
start adrs: 00512
◊
stop adrs: 00750
◊
exit invert
◊
The waveform can be inverted on a section of the waveform defined by the
start
and
stop
addresses. Set the addresses by pressing the appropriate soft-key and making entries directly
from the keyboard or by rotary control.
The data values over the specified section of the waveform are inverted about 0000 each time the
invert
soft-key is pressed.
Press
exit
to return to the
EDIT FUNCTIONS
screen.
Position Markers
Pressing the
position markers…
soft-key calls the
POSITION MARKER EDIT
screen:
POSITION MARKER
EDIT
adrs: 00000
<0>
◊
◊
patterns…
◊
exit clear
all
◊
Position markers are output from SYNC OUT when the source (
src
) is set to
pos’n marker
on the
SYNC OUTPUT SETUP
screen.
Position markers can be set at any or all of the addresses of a waveform either individually, using
the
adrs
(address) soft-key, or as a pattern, using the
patterns…
menu.
A marker can be set directly at an address by pressing the
adrs
soft-key followed by a keyboard
entry; pressing the right-hand soft-key on the
adrs
line then toggles the marker setting between
<1> and <0> as shown in the arrowed brackets. The address can be changed by incrementing
with the
adrs
key, by using the rotary control, or by further keyboard entries; marker settings are
43