TSE DP20-4H, Owner'S Manual

Page: 81 / 242

3. EDC only - If you removed screen (D084), install a new one. Install it with the mesh facing outward.
Install retaining ring (D098).
EDC only - Proper screen orientation
P106 618E
D084
D084
Incorrect screen
orientation
Correct screen
orientation
D098
HDC only - Proper screen orientation
D084
Correct screen
orientation
P109548
HDC only - If you removed screen (D084), install a new one. Install it with the mesh facing inward.
Remove the plug on top of the control to ensure the swashplate feedback pin is properly positioned
in the center of the control module when installing control.
4. Install the control module and six cap screws (D250).
Torque sequence
P106 195E
P106 195E
2
3 4
5
6
1
5. Using a 5 mm internal hex wrench, torque the cap screws (D250) to 13.3 Nm [9.8 lbf ft].
Replace Control Solenoids/Actuator Housing - MP1
1. Disconnect electrical/hydraulic connection and remove the three cap screws (D050) using a 4 mm
internal hex wrench.
2. Remove the solenoid/actuator housing (D025/QD77) and O-ring (D025A/QD26). Discard the O-ring.
Individual coils may be replaced. Use a 12 point 26 mm socket. Torque the coil nut to to 5 N•m [3.7
lbf•ft].
3. Inspect the machined surface on the control. If you find any nicks or scratches, replace the
component.
Service Manual
MP1
Minor Repair
© Danfoss | July 2017 AX00000244en-US0103 | 47