TSE DP20-4H, Owner'S Manual

Page: 14 / 242

SECTION I
INTRODUCTION
GENERAL DESCRIPTION
The TSE Model DP20-4H is a trailer mounted four drum puller powered by a four cylinder diesel
engine and hydrostatic transmission. The speed, torque, and direction of the transmission are
regulated from the elevated, centrally located control panel to allow an infinitely variable control of line
tension and speed within the specified performance parameters of the unit in both the pulling and
tensioning mode of operation. Efficient cable wrapping is promoted by the leadscrew-type levelwind.
WARNING/CAUTION: WHEN THIS SIGN APPEARS ON THESE PAGES, IT INDICATES WHERE
SPECIAL ATTENTION SHOULD BE PAID TO THE INSTRUCTIONS GIVEN. PERSONAL INJURY
OR DAMAGE TO THE EQUIPMENT MAY OCCUR IF THE INSTRUCTIONS ARE NOT
FOLLOWED.
DIMENSIONS
Length
186 inches
Width 96 inches
Height 104 inches (Top of Operator Screen)
PERFORMANCE
1 Full Reel
2,000 lbs @ 3.5 MPH
4 Reels Simultaneously 500 lbs @ 2.0 MPH
Speed Range: 0-4 mph
WARNING: THESE VALUES ARE A MAXIMUM AND MUST NOT BE EXCEEDED.
REEL SPECIFICATIONS
Reel Diameter:
34 inches
Reel Width: 32 1/2 inches (Inside flanges)
Drum Diameter 12 ¾ inches
WARNING: THESE VALUES ARE A MAXIMUM AND MUST NOT BE EXCEEDED.
UNDERCARRIAGE
Axle
Single 8,000 lb capacity
Tires 215/75R17.5
Brakes 12 1/4" X 3 3/8” Electric
Front Jack Manual Screw Type
Rear Stabilizers Pin Type