AV30 PRE-INSTALLATION REQUIREMENTS | AV30 Pre-Installati on Requirements | v. 3.0
3 / 37
INTRODUCTION
Congratulations on your TruSteel equipment purchase! We here at TruSteel are sure you're
going to be impressed at how efficient the the AutoVap recovers your solvent and how EASY
the system is to use.
But, before your AutoVap30 can be installed and run at maximum efficiency, we have to be
sure that your facility is properly set up with all the equipment TruSteel provides you with.
By following the requirements throughout this checklist, you can be sure you will have a quick,
easy install and your AutoVap system will run great for years to come. Setting the stage
properly the first time will save you valuable time and money in the future.
Please take the time to carefully review this manual and refer to it throughout your AutoVap
pre-Installation process.
It is suggested, but not required, to place all ancillary equipment (water heater, chiller, vacuum
pump, PLC) outside of your C1D2 solvent recovery lab.
AUTOVAP30 IMAGES
The AV30 is the most efficient solvent recovery system when comparing throughput to
footprint.
With built in fail safes, alarms, data logging, and remote access, the AV30 stands alone as the
leader in the industry.
How the AutoVap30 Works
The AutoVap30 works by pumping your tincture up through a preheater before being
atomized through a sprayer. The material than falls through a heated, jacketed exchanger
where the solvent evaporates, and is "pulled" by vacuum into the condenser exchanger
which is cooled from a chiller.
The "crude" material is automatically discharge through a pump and the solvent is re-
condensed and automatically discharge through the solvent discharge pump.
The AutoVap30 has a easy to use cleaning cycle to ensure the longevity of your
AutoVap30 system.
