TRUST 910Z POWERC@M OPTICAL ZOOM
6
4
Preparing the camera
4.1
Install the Memory Card
A memory card is not supplied with the camera. You could purchase these cards
separately to increase the number of photographs that the camera can save. The
memory cards which are supported for this camera are SD (Secure Digital) or MMC
(multimedia). Instructions for installing memory card (see also figure 7):
1.
Turn off the camera.
2.
Open the battery holder by pressing on the cover and sliding in the direction
of the arrow toward the outside edge of the camera.
3.
Insert the memory card with the notched corner facing the cover of the
battery holder.
4.
Close the battery cover.
4.2
Install / replace the batteries
See also figure 8.
1.
Turn off the camera.
2.
Open the battery holder on the bottom of the camera by pressing on the
cover and sliding in the direction of the arrow toward the outside edge of the
camera.
3.
Insert batteries into the chamber making sure that the positive
and
negative
ends are properly oriented, as indicated on the compartment’s
interior wall.
4.
Close the battery cover.
The battery condition is shown on the LCD screen (bottom left-hand corner) as
follows:
The batteries are full.
The battery capacity is low. Only a few more photographs can be
taken.
Table 6: Battery conditions
4.3
Placing the camera on the tripod
Screw the tripod to the fixing point (1, figure 3) on the bottom of the camera. Make
sure the tripod is fitted as shown in figure 14, with the middle foot facing the side of
the camera with the USB/TV connection. Move the feet of the tripod as far apart as
possible, so that the camera is stable.
