TRUST 922Z POWERC@M OPTICAL ZOOM
The computer's USB port
does not work.
Check the settings of your
USB port. For more
information, see
www.trust.com/customercar
e/help/usb.
The camera has not been
connected to a USB port.
Connect the camera to a
USB port
Windows does not
detect a new device
after connecting the
camera.
The camera has been
connected to a USB hub
which does not have a
power supply.
Connect the camera to a
USB hub which has a power
supply or to a USB port on
your computer.
After connecting my
camera to my PC for
the first time, I
cannot see an extra
disk drive in
Windows Explorer.
Depends on your system
load, Windows may not
be able to detect the
device so quickly and
assign a proper driver.
When the camera is
connected to a Windows
system for the first time, it
can sometimes take longer
than 5 minutes before
Windows has detected and
installed the default drivers.
This is normal. Wait for
some time and refresh the
contents of the open
Windows Explorer window
by pressing F5. A removable
disk will eventually appear in
the list of folders. Only then
has the driver been fully
configured.
If I disconnect my
camera from the USB
port, I receive a
message saying that
it was not removed
correctly. Why is that
and how should it be
disconnected?
The device was not
turned off in Windows.
Since the camera is a
storage medium, it is
possible that it was being
written to or read by
Windows when it was
disconnected. Abruptly
disconnecting the device
may damage the directory
structure or the memory
layout. The device must,
therefore, be released
before it can be removed
safely.
Carry out following: an icon
is displayed in the right-hand
corner of the taskbar for
disconnecting hardware
(image of a PC card with a
green arrow). Double-click
on this icon and then select
the device that you wish to
disconnect by clicking on
‘Stop’. You will then receive
a message saying that the
device can be disconnected.
U K
Problems with the software
Problem Cause
Possible
solution
19
