7
A
C
G
C
B
E
D
ENGLISH
Assembly
Cutting string replacement and mounting
Harness
1
2
Auxiliary handle
• Install the auxiliary handle as shown in the figure.
• To operate comfortably move the auxiliary handle
trough the string trimmer arm up to the right height.
• Tighten the screws to fix into position.
• Set the harness in the handle ring to support the string
trimmer on the shoulder.
Notch
release
• With the string trimmer turned off, remove the
spool-retaining cap (
A
) turning counter-clockwise.
• Remove the empty spool. Verify it is clean and has no
damaged or worn parts.
• Cut 20´ length of cutting line. Make a loop in the middle
of the line and insert the loop in the spool inner hook
(
B
). Hold the line and wind it clockwise. Double-check each
end of the line is wound in its respective section (upper and
lower). Do not wind too much line. After winding there
shall remain a 0.2” minimum distance between the spool
edge and the wound line.
• Leave approximate 6” unwound on both ends of the
line and insert each one of them in the spool notches (
C
).
This is to prevent the line to unwind while installing the
spool in the brush cutter. Later on you will release the
lines from their notches.
• Set back the spool in its cover passing the ends of each
line through the cover orifices (
D
). If the line is loose or
tangled in this step, wind it again in the spool and secure it
in its notches.
• Set the spool cover in the axis (
E
) and secure the spool
tightening the retention cap (
A
).
• Apply force and pull both ends of the cutting line
outwards to release it from the notches in the upper side
of the spool (
G
).
• Align the safety pin (
a
) of the lower shaft with the
middle hole in the clamp (
b
).
• Press the safety pin down and insert the lower shaft into
the clamp.
• Release the safety pin; ensure that it engages in the hole
on the upper shaft .
• Tighten the locking knob anticlockwise to secure the
connection (
c
).
Shaft
a
b
c
