Truen TCAM-570-X18H, User Manual

Page: 43 / 55

TCAM-570-X18H User Manual
1.3 Megapixel Speed Dome User Manual
43/55
The TCAM-570-X18H has two sensor ports and two alarm ports.
When a decoder instead of a PC client is connected to a TCAM-570-X18H, one system becomes a Local
system and the other a Remote system (Generally a system which is being used by the user is called as
Local system). Then, actions for events can be configured for events from the remote system as well as
for local system. For example, it is possible to turn on an alarm device in local (center) decoder system
when a sensor device in remote (site) IP camera is triggered. Local section configures the actions for
events from local (self) system, and configuration activates local devices and Remote sections configure
the actions for events from remote (peer) system.
The following table lists the possible actions for events.
Action Description
Alarm out Triggers alarm (relay) port.
E-mail
Sends E-mail to the specified address. AVI
file can be attached
FTP Upload AVI file to a specified FTP server
Preset Move to the Preset position
Local & Remote Event Configuration

Sensor1 / Sensor2/ Sensor3 / Sensor4.
Configure the actions when the sensor is activated. Multiple actions can be set for a single event.

On Video Loss
Configure the actions when video input signal is lost. Multiple actions can be set for a single event.

On Motion
Configure the actions when motion is detected. Multiple actions can be set for a single event.

On Disconnect
Configure the actions when the link (connection) with peer system is disconnected. Multiple actions can
be set for a single event.
Alarm and Beep activation duration

Set the duration of alarm or beep activation in case of an event. If it is set to continuous, it will be in
active state until an operator reset it manually.