Truen TCAM-570-X18H, User Manual

Page: 14 / 55

TCAM-570-X18H User Manual
1.3 Megapixel Speed Dome User Manual
14/55
Installation Camera with Brackets
Installation using Ceiling Mount Bracket
①
Remove the ceiling tile from the ceiling and cut a
hole whose diameter is 30~40mm on the ceiling tile
to pass the wire(s) and cable(s) through to the
upside of the ceiling. (In case of the wiring and
cabling through the mounting surface only) Then
prepare the ceiling mount bracket. Pull the wire(s)
for the system as below. (Anchor Bolt 3/8"
×
70)
②
Hook up “Drop Prevention Spring” on main body
to prevent camera from unexpected drop and pull
the wire(s) and cable(s) for the system as below
③
Line up the mold lines and assemble main body
to mount adaptor and turn it. And assemble the
main both with the camera mount adaptor with
the screws. (Torx screw M4X18). Please make
sure the screws are tightly assembled for
waterproof.
④
Screw the dome cover to the main body and
remove the protection vinyl from the dome cover.
Notice

Before starting the installation, make sure that the Camera ID and Protocol are set up properly.

To adjust the installation height from the mounting surface, the pipe and coupler should be needed
between the surface mount part of the ceiling mount bracket and the camera mount part of the ceiling
mount bracket. Note that they are not supplied by the manufacturer.