3.6.4 Using Your 7500 AtomiZer With A Pressure Pot
Using a pressure pot with your 7500 AtomiZer spray gun is very easy. All you need is any size pressure pot, a fluid hose,
a 3/8” diameter air hose and any air compressor 3hp with a 20 gal (75 liter) air tank or larger. We recommend a pressure pot
with two regulators. One to regulate air pressure to the spray gun and a second to regulate air pressure to the pressure pot.
The basic 7500C AtomiZer spray gun is ready to set up for production use with your pressure pot.
If you are converting your 7500 AtomiZer from a cup gun to production, follow these steps first. If not, skip to step one of
Section 3.7 for preparation:
1. Disconnect the air feed tube from the side of the spray gun.
2. Remove the air feed connector (#22, page 33) and reinstall the blanking screw.
3. If you were using a gravity cup, move the blanking cap from the bottom connector to the top.
NOTE: Make sure that the top material connector (#30, page 33) has been capped with the
material blanking cap (#11, page 33).
NOTICE
Do not attempt to remove part# 29 or 30, page 33. Spray gun may leak
internally.
Summary of Contents for Apollo 7500 AtomiZer
Page 32: ...8 Diagram Parts List...
