Troy Built Zero-Turn Tractor, Operator'S Manual

Page: 9 / 44

9 S
ection
2 — A
SSembly
& S
et
-U
p
Note: The positive battery terminal is marked Pos. (+).
The negative battery terminal is marked Neg. (–).
1.
Remove the plastic cover, if present, from the
positive battery terminal and attach the red
cable to the positive battery terminal (+) with
the bolt (a) and hex nut (b). See Figure 2-9.
(b)
(b)
(a)
(a)
(c)
Figure 2-9
2. Remove the plastic cover, if present, from the
negative battery terminal and attach the black
cable to the negative battery terminal (–) with
the bolt (a) and hex nut (b). See Figure 2-9.
3. Position the red rubber boot (c) over the
positive battery terminal to help protect it
from corrosion.
Note: If the battery is put into service after
the date shown on top/side of battery, charge
the battery as instructed in the Product Care
section prior to operating the tractor.
Adjusting the Seat
Lever Adjust
To adjust the position of the seat, pull up and hold
the seat adjustment lever. Slide the seat forward
or rearward to the desired position; then release
the adjustment lever. Make sure seat is locked into
position before operating the tractor. See Figure 2-10.
Figure 2-10
Knob Adjust
To adjust the position of the seat, rotate the seat
forward and locate the clamp knobs (a) on the front
of the seat pan. See Figure 2-11.
(a)
(b)
Figure 2-11
Rotate the clamp knobs (a) to the left and remove
them, slide the seat forward or backward and
re-insert the clamp knobs (a) into one of the four
available positions (b) on the seat pan and into the
seat, then tighten both securely. Make sure the
seat is locked into position before operating the
tractor. See Figure 2-11.
Fuel Fill-Up
Using a good grade of unleaded regular gasoline,
fill the tank (beside the engine on the left side of
the mower). When the fuel tank reaches one inch
from the top of the tank, stop, DO NOT OVERFILL.
Space must be left for expansion.
Notes