![background image](http://html1.mh-extra.com/html/troy-bilt/ls-33-tb/ls-33-tb_operators-manual_1173099009.webp)
Attaching the tongue
Remove the two hex bolts and lock nuts on the front of the
1.
reservoir tank.
NOTE:
The hardware for attaching the tongue to the
reservoir tank is already inserted into the reservoir tank
brackets.
Place the tongue in position and secure with hardware just
2.
removed. See Fig. 3-5.
Remove the reservoir tank from the blocks.
3.
Attaching Beam To Reservoir Tank
Stand the wedge, beam, and cylinder assembly upright
1.
with cylinder toward the top.
NOTE:
This step will require two people.
Remove the hinge pin and cotter pin from the welded
2.
brackets on the beam assembly and move the reservoir
tank assembly in position against the beam.
Lift up on the tongue assembly until the holes are aligned
3.
and insert the hinge pin just removed through brackets on
beam and reservoir tank assembly.
Secure the hinge pin with the cotter pin by bending the
4.
ends of the pin. See Fig. 3-6.
Secure the beam to the tank by pulling out on the vertical
5.
beam lock and rotating it up and over the edge of the
beam.
Lock Nuts
Hex Bolts
Figure 3-5
Hinge Pin
Cotter Pin
Figure 3-6
9
s
ectiOn
3 — a
sseMbly
& s
et
-u
p
Summary of Contents for LS 33 TB
Page 46: ...Notas 8 22...
Page 47: ...23 Secci n 8 Notas...