Troy-Bilt 2890, Operator'S Manual

Page: 10 / 24

10 S
ection
3— A
SSembly
& S
et
-U
p
Adjustments
Skid Shoes
The snow thrower skid shoes are adjusted at the factory. Adjust
them, if desired, prior to operating the snow thrower.
CAUTION:
Always place the Track Lock Lever in the
Gravel position before operating the snow thrower
on gravel surfaces. When operated in the Normal or
Packed Snow position, the snow thrower can easily
pick up and throw loose gravel, causing personal
injury or damage to the snow thrower and
surrounding property.
• For close snow removal on a smooth surface, raise skid
shoes higher on the auger housing.
• Use a middle or lower position when the area to be cleared
is uneven, such as a gravel driveway.
NOTE: If you choose to operate the snow thrower on a gravel
surface, keep the skid shoes in position for maximum clearance
between the ground and the shave plate.
To adjust the skid shoes:
1.
Loosen the four hex nuts (two on each side) and carriage
bolts. Move skid shoes to desired position. See Figure 3-10.
Figure 3-10
2. Make certain the entire bottom surface of skid shoe is
against the ground to avoid uneven wear on the skid shoes.
3. Retighten nuts and bolts securely.
Auger Control
WARNING!
Prior to operating your snow thrower,
carefully read and follow all instructions below.
Perform all adjustments to verify your snow thrower
is operating safely and properly.
Check the adjustment of the auger control as follows:
1.
When the auger control is released and in the disengaged
“up” position, the cable should have very little slack. It
should NOT be tight.
2. In a well-ventilated area, start the snow thrower engine.
Refer to Engine Operator’s Manual.
3. While standing in the operator’s position (behind the snow
thrower), engage the auger.
4. Allow the auger to remain engaged for approximately ten
(10) seconds before releasing the auger control. Repeat this
several times.
5. With the throttle control in the FAST (rabbit) position and
the auger control in the disengaged “up” position, walk to
the front of the machine.
6. Confirm that the auger has completely stopped rotating
and shows NO signs of motion. If the auger shows ANY
signs of rotating, immediately return to the operator’s
position and shut off the engine. Wait for ALL moving parts
to stop before re-adjusting the auger control.
7. To readjust the control cable, loosen the upper hex screw
on the auger cable bracket. See Figure 3-11.
Figure 3-11
8. Position the bracket upward to provide more slack (or
downward to increase cable tension).
9. Retighten the upper hex screw.
10. Repeat steps 2 through 6 above to verify proper
adjustment has been achieved.