12
S
ection
4 — c
ontrolS
and
F
eatureS
Auger Control
The auger control is located on the left handle. Squeeze the
control grip against the handle to engage the augers and start
snow throwing action. Release to stop.
Drive Control / Auger Clutch Lock
The drive control is located on the right handle. Squeeze the
control grip against the handle to engage the track drive. Release
to stop.
The drive control also locks the auger control so that you can
operate the chute directional control without interrupting
the snow throwing process. If the auger control is engaged
simultaneously with the drive control, the operator can release
the auger control (on the left handle) and the augers will remain
engaged. Release both controls to stop the augers and wheel
drive.
NOTE:
Always release the drive control before changing speeds.
Failure to do so will result in increased wear on your machine’s
drive system.
Heated Grips
CAUTION:
It is recommended that you wear
gloves when using the heated grip. If the heated
grip becomes too hot, turn it off.
To activate the heated grips, move the switch found on the rear
of the dash panel into the ON position. To turn off the heated
grips, move the switch found on the rear of the dash panel to the
OFF position.
Steering Trigger Controls
The left and right wheel steering trigger controls are located on
the underside of the handles.
•
Squeeze the right control to turn right.
•
Squeeze the left control to turn left.
CAUTION:
Operate the snow thrower in open
areas until you are familiar with these controls.
Overhead Chute Directional Control
The overhead chute directional control is located in the center of
the snow thrower between the handle panel and lower handle.
To change the direction in which snow is thrown, rotate the
chute directional control.
Summary of Contents for 2890
Page 23: ...Notes 11 23 ...