9
S
ection
3 — A
SSembly
& S
et
-U
p
7.
Remove the hairpin clip from the rear of the chute control
assembly. See Figure 3-7a.
8.
Insert chute directional control rod into rear of the chute
control assembly. See Figure 3-7b. Secure the chute
directional control rod to the chute control assembly with
the hairpin clip removed earlier.
b
a
Figure 3-7
Set-Up
Shear Pins
Replacement auger shear pins and bow tie cotter pins are
included with your snow thrower. Store them in your snow
thrower’s dash panel until needed. See Figure 3-8.
Figure 3-8
Chute Clean-Out Tool
The chute clean-out tool and cord are fastened to the top of the
auger housing with a mounting clip and a cable tie at the factory.
Cut the cable tie before operating the snow thrower.
See Figure 3-9.
Chute Clean-Out Tool
Figure 3-9
Summary of Contents for 2890
Page 23: ...Notes 11 23 ...