EN
4
oil heater IDX 30 D
Device depiction
IDX 30 D
THERMOST
AT CONT
ROL
ROOM TEMP
.
CLOSE
OPEN
1
2
3
4
5
6
7
8
9
10
12
11
No.
Designation
1
Upper part of the housing
2
Air inlet with protective grid
3
Transport handle
4
Fan and motor
5
Pressure gauge
6
Tank
7
Frame
8
Control panel
9
Fuel tank cap
10
Wheel
11
Tank filling level indication
12
Air outlet
Transport and storage
Note
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
To make the device easier to transport, it is fitted with wheels.
Before
transporting the device, proceed as follows:
•
Switch off the device.
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Do not use the power cable to drag the device.
•
Allow the device to cool down sufficiently.
While
transporting the device, observe the following:
•
Slightly lift the device by the transport handle (2) until the
rear support no longer touches the ground.
•
Wheel the device to the desired position.
Storage
Before
storing the device, proceed as follows:
•
Switch off the device.
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Allow the device to cool down sufficiently.
When the device is not being used, observe the following
storage conditions:
•
dry and protected from frost and heat
•
in an upright position where it is protected from dust and
direct sunlight
•
with a cover to protect it from invasive dust if necessary
