5
EN
oil heater IDX 30 D
Assembly and installation
Scope of delivery
•
1 x Device
•
1 x Transport handle
•
2 x Wheel
•
2 x Wheel cap
•
1 x Axle
•
2 x Locking ring
•
1 x Frame
•
4 x Small screw
•
4 x Large screw
•
1 x Manual
Unpacking the device
1. Open the cardboard box and take the device out.
2. Completely remove the packaging.
3. Fully unwind the power cable. Make sure that the power
cable is not damaged and that you do not damage it during
unwinding.
Assembly
Upon delivery the device is already partially preassembled. The
wheels, transport handle and frame still need to be mounted.
Assembling the wheels
Prior to initial start-up, the wheels and the axle must be
attached to the frame. To do so, please proceed as follows:
1. Slide the axle through the openings at the frame.
2. Attach both wheels to the axle.
3. Attach the locking rings to the axle.
4. Fasten the wheel caps to the wheels.
Info
If necessary, the frame can be disassembled again
(e.g. for storage). To remove the wheels from the axle,
you can carefully loosen the wheel caps and locking
rings by means of a slotted screwdriver.
Assembling transport handle and frame
1. Place the device on the frame. Make sure that the holes for
the screws are positioned flush above each other.
2. First, bolt the 4 small screws to the frame.
3. Screw the nuts to the screws from below.
4. Place the transport handle on the rear section.
5. Bolt the 4 large screws to the transport handle, device and
frame.
IDX 30 D
THERMOST
AT CON
TROL
ROOM
TEMP.
CLOSE
OPEN
