TrojanTwo User Guide v3.8
Page | 66
13.3.7
Media Settings
Media Settings Basic:
TOF mode: TOF (Top Of Form)
depending on used label media:
Continuous
(no gaps between labels)
Diecut
(gaps between labels, the labels are pre die-cut on the liner)
Blackmark
(pre-printed blackmarkings on the media, blackmarks can be outside or inside on
roll.)
Unwinder label position:
Inside/Outside. Unwinder is rotating according to printing inside or
outside of the label roll.
Rewinder label position:
Inside/Outside. Rewinder is rotating according to printing inside or
outside of the label roll.
TOF offset (mm):
Top Of From (top of label) can be +/- depending on moving the top of the image
up or down on label.
NOTE:
limits -160mm
+160mm
BOF offset (mm):
Bottom of Form (bottom of label) can be +/- depending on moving the bottom of
the image up or down on label.
NOTE:
limits 0mm
100mm
Left offset (mm):
Moving printed image towards left or right compared to the left edge of the
printhead.
NOTE:
limits -127mm
222mm
Square meter/Label cost:
Price of one label for die cut material. Square meter price for Continuous
and Blackmark label material. Used for total cost/label calculation. (See section 13.2.3)
Gap size:
Setting the gap size between printed labels.
NOTE: Maximum gap is 65mm.
Save & Apply
Save as profile
Saved Profiles List
Delete Profile
