10
15
OPERATION
The lamp
must
be replaced after 12
months of operation. Failure to
replace the lamp will reduce the
disinfection strength of the
TrojanUVMax
™
system.
TrojanUVMax™ Models
A, B, and C
Power Supply
Model A is 104-126 at 60Hz or
216-253V at 50Hz. Models B & C
are 90-140V or 190-265V at 50 or
60Hz.
For protection from power
surges a surge protector must be
employed.
Visual Alarm
When the unit is operating properly,
the LED on the ballast will be green.
If the lamp is not operating, the LED
will not light.
Audible Alarm
When the unit is operating properly,
no sound will be emitted. If the
lamp is not operating, the unit’s
alarm will sound until either the
problem is corrected or the system
is unplugged from the electrical
outlet.
Note:
If the system is
unplugged the water will not be
disinfected and the distribution lines
will have to be shocked.
The 230V version of Unit A is not
equipped with an audible alarm.
If you experience either or both
alarms, see the Troubleshooting
Section of this manual (p.20).
TrojanUVMax™ Models
D, E, F, Pro7, and
Pro15
Power Supply
Models D, E, F, Pro7, and Pro15
have an auto ranging constant
current power supply that will
accept 90-265V at 50 or 60Hz.
Visual Alarm
During normal operation the LED
light will be green. The LED is
always on while the lamp is on.
• The LED will turn amber after
11 months of operation or, on
the Plus models, if the sensor
detects a low UV output.
• The LED will turn red if the
lamp is not operating properly
or if the UV signal from the
sensor is below the set point.
• After 12 months of lamp
operation, the LED will turn red,
indicating that the lamp must be
replaced.
Audible Alarm
During normal operation no sound
is emitted.
• If the lamp is not operating or
the UV signal from the sensor is
low, the unit’s alarm will sound.
• After 12 months of lamp
operation, the unit’s alarm will
sound.
If you experience either or both
(audible and visual) alarms, see
the Troubleshooting Section of this
manual (p.20).
Elapsed Time Meter
The Elapsed Time Meter shows you
the number of months that your
lamp has been operating. You
must
replace the lamp after it has
been operating for 12 months.
• After 11 months the LED turns
amber.
• After 12 months the LED turns
red and an alarm sounds.
• After 14 months the alarm
postpone is disabled, indicating
that the lamp
must
be replaced
and that it is not providing
proper disinfection.
• After lamp replacement,
this meter must be reset (see
Elapsed Time Meter Re-Set).
Figure 1
Figure 2
Figure 4
Figure 5
Figure 6
Figure 7
Figure 11
Figure 8
Figure 12
Figure 9
Figure 10
Figure 3
